Competent Person vs Qualified Person
The OSHA Definitions and Who Does What
OSHA assigns each crane task to a competent person, a qualified person, or both. Here is the difference and who does what.
Reviewed November 2026 against 29 CFR 1926.1401, 1926.1412.
Side by Side
| Competent person | Qualified person | |
|---|---|---|
| Core of the definition | Identifies hazards and is authorized to fix them | Has the knowledge to solve problems in the subject |
| Needs authority to stop work or correct? | Yes. It is half the definition | Not part of the definition |
| Needs a degree or certificate? | No | A degree, certificate or professional standing, or extensive knowledge, training and experience |
| Chosen by | The employer | The employer |
| Can one person be both? | Yes | Yes |
Definitions: 29 CFR 1926.1401.
Who Does What on a Crane Job
| Task | OSHA assigns it to |
|---|---|
| Each-shift and monthly crane inspection | Competent person |
| Each-shift wire rope inspection | Competent person |
| Annual / comprehensive inspection | Qualified person |
| Post-assembly, repair and modification inspections | Qualified person |
| Directing assembly and disassembly (A/D director) | Both, or a competent person assisted by qualified persons |
| Supervising pick and carry | Competent person |
| Adjusting for wind, ice and snow | Competent person |
| Planning a multiple-crane lift | Qualified person |
| Directing a multiple-crane lift | Both, or a competent person assisted by qualified persons |
| Deciding it is safe to resume after the operator stops a lift over a safety concern | Qualified person |
| Deciding whether to hoist personnel in wind over 20 mph | Qualified person |
| Designing a personnel platform | Qualified person familiar with structural design |
| Rigging loads when workers are in the fall zone | Qualified rigger, which means a rigger who is a qualified person |
A Way to Remember It
Competent = can see it and can stop it. The foreman, the operator, the person on the ground with authority.
Qualified = can work out the answer. The inspector, the engineer, the rigger who can figure out a lift that is not in the book.
Other roles build on these two. A qualified rigger is a rigger who meets the qualified person definition. The A/D director has to be both.
5 Practice Questions: Competent person vs qualified person
From the question bank in the app. Pick an answer, then open the explanation. For a scored test, try the NCCCO core practice test.
Inspections
1. A "competent person," as defined by OSHA, is one who:
- AIs capable of identifying existing and predictable hazards and has authorization to take prompt corrective measures to eliminate them
- BHolds an engineering degree in crane design
- CHas operated cranes for at least 20 years
- DIs employed directly by the crane manufacturer
Show answer
Answer: A. Is capable of identifying existing and predictable hazards and has authorization to take prompt corrective measures to eliminate them. OSHA's definition has two parts: the ability to identify hazards and the authority to correct them. Degrees and tenure alone do not make someone a competent person.
Standards
2. A "qualified person," as defined by OSHA, is one who:
- ABy possession of a recognized degree, certificate, or professional standing, or by extensive knowledge, training, and experience, has successfully demonstrated the ability to solve problems relating to the subject matter and work
- BCan identify hazards and has authority to stop the work
- CHas attended a single safety orientation
- DIs the most senior employee on the crew
Show answer
Answer: A. By possession of a recognized degree, certificate, or professional standing, or by extensive knowledge, training, and experience, has successfully demonstrated the ability to solve problems relating to the subject matter and work. OSHA's qualified person definition centers on demonstrated problem-solving ability via credentials or extensive knowledge/experience. Hazard identification plus authority to correct describes a competent person instead.
Standards
3. A 'competent person' under OSHA is one who can identify hazards AND…
- AIs authorized to take prompt corrective measures
- BHolds a professional engineering degree
- CIs appointed in writing by OSHA
- DHas ten years of experience
Show answer
Answer: A. Is authorized to take prompt corrective measures. Competent = identifies hazards plus AUTHORITY to correct them. Trap: a 'qualified' person has credentials/expertise; a 'designated' person is simply assigned a task.
General Knowledge
4. OSHA 1926.1412 assigns the annual/comprehensive inspection to a qualified person. Who must conduct the SHIFT inspection?
- AA competent person
- BA qualified person
- CA designated person
- DA certified crane operator
Show answer
Answer: A. A competent person. Role-confusion trap: the QUALIFIED person handles the annual inspection; the shift inspection belongs to a COMPETENT person — one who can identify hazards and has the authority to correct them.
Technical Knowledge
5. Ensuring that a qualified person is designated as the lift director is the responsibility of the…
- ASite supervisor
- BCrane owner
- CCrane operator
- DRigger
Show answer
Answer: A. Site supervisor. The site supervisor must ensure a qualified person is designated as lift director.
Study the Whole Exam, Not 20 Questions
5,000+ practice questions across Core and every specialty, load chart trainers with the rating table on screen, timed exam simulations, and the pass guarantee.
Competent person vs qualified person: Questions & Answers
What is a competent person under OSHA?
What is a qualified person under OSHA?
Is a qualified person higher than a competent person?
Who decides if someone is competent or qualified?
Is a certified crane operator a qualified person?
This page is a study aid. It summarizes federal OSHA rules and industry standards and is not a substitute for the regulation, the manufacturer's manual or your employer's procedures. State plans and site rules can be stricter.