NCCCO TLL • FREE PRACTICE TEST

Telescopic Boom Swing Cab (TLL)
Free Practice Test

The swing cab specialty is the most common mobile crane designation: hydraulic truck cranes and rough-terrain cranes whose cab rotates with the upper.

Reviewed November 2026. 20 questions, answers explained, no sign-up.

The CCO TLL exam covers telescopic boom cranes with a swing cab, where the operator rides on the rotating upper. It has 28 questions in 60 minutes with a calculator allowed, and about 35% is load chart work. You also need the Core exam and a TLL practical.
NCCCO TLL
Swing Cab — General
Question 1 of 20

The TLL's 76-degree maximum boom angle applies when the crane is…

  1. ALifting on tires
  2. BLifting on fully extended outriggers
  3. CLifting with the fly erected
  4. DOperating in any configuration

Exam Format and Fees

ExamQuestionsTimeCalculatorFee
Core written (all mobile cranes)9590 minNo$140
TLL specialty written2860 minYes$80
TLL practical———$70

Sources: CCO Mobile Crane Operator Candidate Handbook, nccco.org/fees.

What This Test Covers

  • ✓Rough-terrain and truck crane setup
  • ✓Outriggers and blocking
  • ✓Boom angle and radius limits
  • ✓Swing cab load chart reading
  • ✓Deductions and net capacity
  • ✓Telescoping and extension modes

Want the full picture first? Read the TLL swing cab certification guide.

20 TLL Swing Cab Practice Questions With Answers

Read through these at your own pace. Pick an answer, then open the explanation. The scored test above deals a different set each time.

Swing Cab — General

1. The TLL's 76-degree maximum boom angle applies when the crane is…

  1. ALifting on tires
  2. BLifting on fully extended outriggers
  3. CLifting with the fly erected
  4. DOperating in any configuration
Show answer

Answer: A. Lifting on tires. Trap: attaching the limit to the wrong setup. The 76-degree cap protects backward stability ON TIRES; on outriggers no such boom-angle limit applies.

Swing Cab — Load Charts

2. A swing-cab telescopic crane is lowering below grade. Per the manufacturer, how many full wraps must remain on the drum?

  1. AAt least 2 full wraps (some manufacturers require 3)
  2. B1 full wrap
  3. CHalf a wrap past the anchor
  4. DNo minimum — the rope anchor holds the load
Show answer

Answer: A. At least 2 full wraps (some manufacturers require 3). The rope anchor alone is not designed to hold the load — ASME B30.5 and manufacturer charts require a minimum of two full wraps remaining on the drum at all times; some manufacturers specify three. Always check your chart’s notes.

Swing Cab — General

3. Setting the TLL's outrigger beams for a lift, you may use…

  1. AAny of the three positions — as long as ALL beams match
  2. BAny mix of lengths, if every float is fully supported
  3. CThe fully extended position only
  4. DIntermediate on the load side, retracted opposite
Show answer

Answer: A. Any of the three positions — as long as ALL beams match. Trap: 'floats supported' sounds sufficient, but the beams must all be at the SAME position — all retracted, all intermediate, or all fully extended.

Swing Cab — Load Charts

4. Lifting from the TLL's auxiliary head, you enter the boom chart using…

  1. AYour actual boom length PLUS 2 feet
  2. BYour actual boom length MINUS 2 feet
  3. CYour actual boom length, unchanged
  4. DThe boom length plus the length of the fly
Show answer

Answer: A. Your actual boom length PLUS 2 feet. Trap: skipping or reversing the correction. The auxiliary head adds 2 ft of effective boom length, pushing you toward a longer chart entry — never subtract it.

Swing Cab — General

5. Maximum travel speed for a TLL pick-and-carry operation is…

  1. A2.5 mph
  2. B5 mph
  3. C10 mph
  4. DWhatever the roadway safely allows
Show answer

Answer: A. 2.5 mph. Trap: 5 mph is a commonly quoted generic figure. This manufacturer limits pick and carry to 2.5 mph, boom centered over the front, travel swing lock engaged, and the load restrained.

Swing Cab — Load Charts

6. Your TLL boom length falls between two listed columns. You use…

  1. AWhichever neighboring length gives the LESSER capacity
  2. BAlways the next LONGER boom length
  3. CAlways the next SHORTER boom length
  4. DThe average of the two ratings
Show answer

Answer: A. Whichever neighboring length gives the LESSER capacity. Trap: 'always next longer' is the radius-style rounding rule. For in-between boom lengths on this chart you must compare BOTH adjacent columns and take the lesser rating.

Swing Cab — General

7. Operating this crane on tires, the boom angle must not exceed…

  1. A76 degrees
  2. B80 degrees
  3. C65 degrees
  4. D45 degrees
Show answer

Answer: A. 76 degrees. Above 76° on tires the crane loses backward stability and can tip.

Swing Cab — Load Charts

8. The 34-ft offset fly is ERECTED but you are lifting from the main boom. The fly deducts…

  1. A4,400 lbs
  2. B900 lbs
  3. CNothing — it is not in use
  4. DIts actual weight only
Show answer

Answer: A. 4,400 lbs. Trap: 900 lbs is the STOWED figure. Erected but not used, the 34-ft fly's leverage raises the deduction to 4,400 lbs — and 'not in use' never means zero.

Swing Cab — General

9. When lifting on outriggers, the outrigger beams must be…

  1. AAll extended to the same length
  2. BExtended to any mix of lengths
  3. CFully extended only
  4. DRetracted on the load side
Show answer

Answer: A. All extended to the same length. All beams must match: fully retracted, intermediate, or fully extended.

Swing Cab — Load Charts

10. The lift needs only 2 parts of line but the block is reeved with 5. The three extra parts…

  1. ADeduct 1 lb per foot of the excess wire rope
  2. BDeduct nothing — extra parts add capacity
  3. CDeduct 10 lbs per extra part
  4. DRequire re-reeving before any lift is allowed
Show answer

Answer: A. Deduct 1 lb per foot of the excess wire rope. Trap: extra parts DO raise line-pull capacity, but rope beyond what the pick requires is excessive reeving and still deducts at 1 lb per foot of the excess cable.

Swing Cab — General

11. In the TLL's boom mode A, which boom sections telescope?

  1. AOnly the inner mid section
  2. BAll three power sections simultaneously
  3. CThe inner and outer mid sections
  4. DOnly the tip section
Show answer

Answer: A. Only the inner mid section. In boom mode A only the inner mid section telescopes; in mode B the inner mid, outer mid, and tip sections telescope simultaneously and must be extended or retracted equally.

Swing Cab — Load Charts

12. Capacities on tires or fully retracted outriggers are limited to what % of tipping?

  1. A75%
  2. B85%
  3. C100%
  4. D50%
Show answer

Answer: A. 75%. Extended outriggers: 85% of tipping. Tires or retracted: 75%.

Swing Cab — General

13. Pick-and-carry operations on the TLL are restricted to a maximum speed of…

  1. A2.5 mph
  2. B5 mph
  3. C10 mph
  4. D1 mph
Show answer

Answer: A. 2.5 mph. On-tire pick and carry is limited to 2.5 mph with the boom centered over the front, the two-position travel swing lock engaged, and the load restrained from swinging.

Swing Cab — Load Charts

14. For concrete bucket work, bucket plus load must not exceed…

  1. A80% of rated capacity
  2. B100% of rated capacity
  3. C50% of rated capacity
  4. D7,000 lbs always
Show answer

Answer: A. 80% of rated capacity. Bucket duty is limited to 80% of the chart rating.

Swing Cab — General

15. What does the chart's 'no load stability limit' identify?

  1. AThe radius beyond which the boom may not be positioned even with no load on the hook
  2. BThe heaviest load that may be carried on tires
  3. CThe minimum counterweight for bare-boom travel
  4. DThe wind speed that requires lowering the boom
Show answer

Answer: A. The radius beyond which the boom may not be positioned even with no load on the hook. The no load stability limit is the radius beyond which positioning the boom plus load handling equipment is prohibited — the crane may overturn without any load on the hook.

Swing Cab — Load Charts

16. The LEAST stable working area on outriggers is…

  1. AOver the side
  2. BOver the rear
  3. COver the front
  4. DDirectly over an outrigger
Show answer

Answer: A. Over the side. Over the side is this crane's least stable quadrant.

Swing Cab — General

17. What does "swing cab" mean on a telescopic boom crane?

  1. AThe operator's cab is mounted on the superstructure and rotates with the boom
  2. BThe cab can be folded down for transport clearance
  3. CThe cab swings open sideways for entry
  4. DThe cab is suspended on springs to reduce vibration
Show answer

Answer: A. The operator's cab is mounted on the superstructure and rotates with the boom. On a swing cab crane the cab is part of the rotating upperworks, so the operator always faces the boom and load.

Swing Cab — Load Charts

18. For excessive reeving, deduct…

  1. A1 lb for each extra foot of wire rope
  2. B10 lbs per extra part
  3. C5% of gross
  4. DNothing — reeving is free
Show answer

Answer: A. 1 lb for each extra foot of wire rope. Any reeving beyond the minimum required counts: 1 lb per extra foot.

Swing Cab — General

19. On a swing cab crane, what is "tail swing"?

  1. AThe arc the rear of the rotating superstructure (counterweight) sweeps beyond the chassis when slewing
  2. BThe side-to-side sway of a suspended load
  3. CThe rearward tilt of the boom in the stowed position
  4. DThe travel of the hook block when the swing brake is released
Show answer

Answer: A. The arc the rear of the rotating superstructure (counterweight) sweeps beyond the chassis when slewing. Tail swing is the swept path of the counterweight/rear superstructure, a key clearance hazard that must be barricaded.

Swing Cab — Load Charts

20. Your boom length falls between two listed lengths. Use the rating for…

  1. ANext longer or next shorter length — whichever is smaller
  2. BAlways the next longer length
  3. CAlways the next shorter length
  4. DThe average
Show answer

Answer: A. Next longer or next shorter length — whichever is smaller. For in-between boom lengths, use the smaller of the neighboring ratings; for radii, the next larger radius.

Study the Whole Exam, Not 20 Questions

5,000+ practice questions across Core and every specialty, load chart trainers with the rating table on screen, timed exam simulations, and the pass guarantee.

TLL Swing Cab Exam FAQ

How many questions are on the TLL specialty exam?
28 questions in 60 minutes, and a calculator is allowed. You also need the 95-question Core exam and the TLL practical to earn the designation.
What is on the TLL written exam?
Site (about 23%), Operations (about 23%), Technical Knowledge (about 19%) and Load Charts (about 35%). Load chart problems use the manufacturer charts supplied with the exam.
How much does the TLL certification cost?
CCO lists $80 for the TLL written exam and $70 for the TLL practical, plus $140 for Core if you don't already have it. See every fee.
Are these the real exam questions?
No. CCO doesn't publish its exam items. These are original practice questions on the same swing cab topics.
What is the difference between TLL and TSS?
TLL is the swing cab: the operator's cab rotates with the upper. TSS is the fixed cab: the operator's station stays on the carrier, as on most boom trucks.