NCCCO TSS • FREE PRACTICE TEST

Telescopic Boom Fixed Cab (TSS)
Free Practice Test

The fixed cab specialty covers telescopic cranes run from a station that doesn't rotate with the boom, which includes most boom trucks.

Reviewed November 2026. 20 questions, answers explained, no sign-up.

The CCO TSS exam covers telescopic boom cranes with a fixed cab, including most boom trucks. It has 28 questions in 60 minutes with a calculator allowed, and about 35% is load chart work. You also need the Core exam and a TSS practical.
NCCCO TSS
Fixed Cab — General
Question 1 of 20

When a telescopic boom crane is engaged in a pick-and -carry operation, the rated tipping capacity is based on what percentage of the total tipping capacity?

  1. A75%
  2. B70%
  3. C80%
  4. D85%

Exam Format and Fees

ExamQuestionsTimeCalculatorFee
Core written (all mobile cranes)9590 minNo$140
TSS specialty written2860 minYes$80
TSS practical———$70

Sources: CCO Mobile Crane Operator Candidate Handbook, nccco.org/fees.

What This Test Covers

  • ✓Boom truck setup and stabilizers
  • ✓Fixed-cab operating stations
  • ✓Load chart areas of operation
  • ✓Deductions and net capacity
  • ✓Over-the-cab and front restrictions
  • ✓Daily inspection items

Want the full picture first? Read the TSS fixed cab certification guide.

20 TSS Fixed Cab Practice Questions With Answers

Read through these at your own pace. Pick an answer, then open the explanation. The scored test above deals a different set each time.

Fixed Cab — General

1. When a telescopic boom crane is engaged in a pick-and -carry operation, the rated tipping capacity is based on what percentage of the total tipping capacity?

  1. A75%
  2. B70%
  3. C80%
  4. D85%
Show answer

Answer: A. 75%. Pick-and-carry (on-rubber) ratings for telescopic boom cranes are based on 75% of the tipping capacity, providing the required stability margin while the crane moves with the load.

Fixed Cab — Load Charts

2. Working a fixed-cab chart at long radius and deep pick: per the manufacturer, how many full wraps must remain on the drum?

  1. AAt least 2 full wraps (some manufacturers require 3)
  2. B1 full wrap
  3. CHalf a wrap past the anchor
  4. DNo minimum — the rope anchor holds the load
Show answer

Answer: A. At least 2 full wraps (some manufacturers require 3). The rope anchor alone is not designed to hold the load — ASME B30.5 and manufacturer charts require a minimum of two full wraps remaining on the drum at all times; some manufacturers specify three. Always check your chart’s notes.

Fixed Cab — General

3. The safest MAXIMUM speed for a crane performing a pick-and-carry operation is:

  1. Athe manufacturer’s recommended speed limit.
  2. Ba speed NOT to exceed 5 m.p.h.
  3. Cthe speed recommended by ASME B30.5
  4. Da speed appropriate to the condition of the job site roadway.
Show answer

Answer: A. the manufacturer’s recommended speed limit.. The manufacturer sets the maximum allowable travel speed for pick-and-carry operations in the load chart/operator's manual, and that recommended speed limit is the governing maximum.

Fixed Cab — Load Charts

4. Allowable line pull for ONE part of 9/16-in ROTATION-RESISTANT rope on the TSS is…

  1. A7,400 lbs
  2. B8,500 lbs
  3. C12,920 lbs
  4. D17,000 lbs
Show answer

Answer: A. 7,400 lbs. Trap: 8,500 lbs is the 6x25 IWRC figure at 3.5:1. Rotation-resistant rope's required 5.0:1 design factor drops the single-part pull to 7,400 lbs.

Fixed Cab — General

5. While performing a pick and carry operation, what precaution should be taken?

  1. Ahave the boom in line with the direction of travel.
  2. Bhave the boom raised to maximum boom angle.
  3. Cplace the boom at minimum boom angle.
  4. Dhave the block and ball as close to the boom tip as possible.
Show answer

Answer: A. have the boom in line with the direction of travel.. During pick and carry, the boom must be kept in line with the direction of travel (carried directly over the front) to keep the load stable and within the chart's pick-and-carry limits.

Fixed Cab — Load Charts

6. A hose reel is mounted on the boom head but plays no part in the lift. From gross capacity you deduct…

  1. A190 lbs — installed equipment deducts whether used or not
  2. BNothing — it is not being used
  3. C260 lbs
  4. D120 lbs
Show answer

Answer: A. 190 lbs — installed equipment deducts whether used or not. Trap: 'not in use' does not mean 'no deduction.' The 190-lb hose reel deducts whenever installed; 260 lbs is the single-sheave block and 120 lbs the ball.

Fixed Cab — General

7. What item is permissible to be removed from a carry deck crane?

  1. Aboom extension.
  2. Brollover protective structure.
  3. Canti-two-block device.
  4. Dfire extinguisher
Show answer

Answer: A. boom extension.. The boom extension (jib) is an optional attachment that may be removed. The ROPS, anti-two-block device, and fire extinguisher are required safety equipment and must remain on the crane.

Fixed Cab — Load Charts

8. Allowable line pull is 8,500 lb per part. To lift 25,000 lbs you need at least…

  1. A3 parts of line
  2. B2 parts of line
  3. C4 parts of line
  4. D5 parts of line
Show answer

Answer: A. 3 parts of line. 2 parts = 17,000 lb — too little. 3 parts = 25,500 lb — enough.

Fixed Cab — General

9. OSHA/B30.5 requires 2 wraps of load line on the drum, but the TSS manufacturer's chart says 3. How many wraps must remain?

  1. A3 — the manufacturer's stricter requirement governs
  2. B2 — OSHA minimums always govern
  3. C1 — if an anti-two-block device is fitted
  4. DEither, at the operator's discretion
Show answer

Answer: A. 3 — the manufacturer's stricter requirement governs. Trap: the familiar 2-wrap B30.5 minimum. The manufacturer requires 3 wraps, and a stricter manufacturer rule supersedes the generic minimum.

Fixed Cab — Load Charts

10. The TSS chart gives 7,690 lbs gross. A 260-lb block and 120-lb overhaul ball are rigged. What can you actually lift?

  1. A7,310 lbs
  2. B7,690 lbs
  3. C7,430 lbs
  4. D7,570 lbs
Show answer

Answer: A. 7,310 lbs. 7,690 − (260 + 120) = 7,310 lbs net.

Fixed Cab — General

11. The swing-around jib is STOWED on its brackets. Lifting from the main boom point is…

  1. APermitted — just take the stowed-jib deduction
  2. BNot intended or approved by the manufacturer
  3. CProhibited unless the jib is removed entirely
  4. DLimited to 50% of chart capacity
Show answer

Answer: A. Permitted — just take the stowed-jib deduction. Trap: the reversed condition. Main-boom lifts are prohibited only with the jib ERECTED; with it stowed you may lift from the main, deducting the stowed jib's weight.

Fixed Cab — Load Charts

12. You need to lift a net load of 7,000 lbs with the single-sheave block (260 lbs) and overhaul ball (120 lbs) rigged. What gross capacity must the TSS chart show?

  1. A7,380 lbs
  2. B7,000 lbs
  3. C7,260 lbs
  4. D7,120 lbs
Show answer

Answer: A. 7,380 lbs. 7,000 + 260 + 120 = 7,380 lbs gross — the chart figure must meet or exceed the load plus all deductions.

Fixed Cab — General

13. Carry deck jib (boom extension) capacities are based on…

  1. AStructural strength — not stability
  2. BStability — 85% of tipping
  3. CStability — 75% of tipping
  4. DMain boom length
Show answer

Answer: A. Structural strength — not stability. Trap: assuming every chart number is a tipping number. Jib capacities are limited by the structural strength of the jib and its attachment — which is why the jib chart reads by boom angle regardless of boom length.

Fixed Cab — Load Charts

14. Per the TSS specifications, what wire rope is furnished on the crane?

  1. A260 ft of 9/16-in 6×25 EIPS IWRC
  2. B300 ft of 1/2-in 6×19 FC
  3. C260 ft of 3/4-in Type RB
  4. D104 ft of 9/16-in 8×36
Show answer

Answer: A. 260 ft of 9/16-in 6×25 EIPS IWRC. The specs list 260 feet of 9/16-in (14.3 mm) EIPS IWRC wire rope.

Fixed Cab — General

15. Pick-and-carry (on-rubber) ratings for a telescopic boom crane are based on what percent of tipping?

  1. A75%
  2. B85%
  3. C80%
  4. D100%
Show answer

Answer: A. 75%. Trap: 85% is the on-outriggers figure for truck cranes. On rubber — including pick and carry — stability ratings drop to 75% of tipping.

Fixed Cab — Load Charts

16. Per the TSS specifications, what is the maximum tip height on the main boom?

  1. A79 ft
  2. B68 ft
  3. C118 ft
  4. D101 ft
Show answer

Answer: A. 79 ft. Maximum tip height is 79 ft on the main boom (101 ft with the fixed jib, 118 ft with the telescopic jib extended).

Fixed Cab — General

17. Lifting from the main boom point while the swing-around jib is erected is…

  1. ANot intended or approved
  2. BFine under 50% capacity
  3. CAllowed with a spotter
  4. DAllowed below 40 ft boom
Show answer

Answer: A. Not intended or approved. The manufacturer prohibits main-boom-point lifts with the jib erected.

Fixed Cab — Load Charts

18. What is the minimum breaking strength of the TSS crane’s 9/16-in 6×25 IWRC rope?

  1. A29,750 lbs
  2. B34,000 lbs
  3. C29,600 lbs
  4. D25,500 lbs
Show answer

Answer: A. 29,750 lbs. The line pull chart notes a 29,750-lb (13,494 kg) minimum breaking strength for the 6×25 IWRC rope.

Fixed Cab — General

19. This crane's chart requires at least how many wraps of load line on the drum?

  1. A3
  2. B2
  3. C1
  4. D5
Show answer

Answer: A. 3. The manufacturer requires 3 wraps — manufacturer rules beat the generic 2-wrap minimum when stricter.

Fixed Cab — General

20. The TSS crane's boom elevation working range runs from what angle below horizontal to what angle above?

  1. A13° below to 80° above
  2. B0° to 90°
  3. C5° below to 76° above
  4. D13° below to 90° above
Show answer

Answer: A. 13° below to 80° above. The boom elevation cylinder works from 13 degrees below horizontal to 80 degrees above it.

Study the Whole Exam, Not 20 Questions

5,000+ practice questions across Core and every specialty, load chart trainers with the rating table on screen, timed exam simulations, and the pass guarantee.

TSS Fixed Cab Exam FAQ

How many questions are on the TSS specialty exam?
28 questions in 60 minutes, and a calculator is allowed. You also need the 95-question Core exam and the TSS practical to earn the designation.
What is on the TSS written exam?
Site (about 23%), Operations (about 23%), Technical Knowledge (about 19%) and Load Charts (about 35%). Load chart problems use the manufacturer charts supplied with the exam.
How much does the TSS certification cost?
CCO lists $80 for the TSS written exam and $70 for the TSS practical, plus $140 for Core if you don't already have it. See every fee.
Are these the real exam questions?
No. CCO doesn't publish its exam items. These are original practice questions on the same fixed cab topics.
Is a boom truck TLL or TSS?
Most boom trucks are operated from a fixed station, so they fall under TSS (Telescopic Boom, Fixed Cab).